Page MenuHome

Fix T60829: DXF Import: Unit Scale Not Applied to Circles
ClosedPublic

Authored by Philipp Oeser (lichtwerk) on Jan 25 2019, 11:14 AM.

Diff Detail

Event Timeline

Seems like projection wasnt done at the lower level for circles/ellipses.
However I am not quite sure if this was supposed to be happening at a higher level?
Just a little unsure because I found this comment for arcs:

  1. curve is None means arc is called from bulge conversion
  2. nothing should be projected at this stage, since the
  3. lwpolyline (the only entity with bulges) will be projected
  4. as a whole afterwards (small little error; took ages to debug)

Eeeh, no, never worked on that even… I’d say try to poke @Campbell Barton (campbellbarton) again, maybe? Otherwise, just commit, you'll get reports soon enough if you break something ;)

This revision was not accepted when it landed; it landed in state Needs Review.Mar 9 2019, 5:14 PM
This revision was automatically updated to reflect the committed changes.