Page MenuHome

Curve "Fill Caps" checkbox is always active
Needs RevisionPublic

Authored by Damian (damian) on Sep 12 2019, 7:38 PM.

Details

Summary

When using curve with geometry, produced by setting parameter (Bevel)Depth greater than zero it would be useful to have Caps on the ends of that curve whenever the Bevel Object is used or not.
This little patch enables it. Although, if the Extrude parameter is set to greater than zero, Fill Caps work oddly, generating only half of the Cap. I hope to find the solution, but still, it is better than nothing.

In many cases, this feature would make use of extra circle curves obsolete, hence save memory.

Diff Detail

Repository
rB Blender

Event Timeline

This seems to be a little more difficult. See T68814 and rB3b3d811bf0a7e1a6.

Also, please remove the old code and don't just comment it out.

Jacques Lucke (JacquesLucke) requested changes to this revision.Fri, Sep 20, 2:06 PM
This revision now requires changes to proceed.Fri, Sep 20, 2:06 PM

This seems to be a little more difficult. See T68814 and rB3b3d811bf0a7e1a6.
Also, please remove the old code and don't just comment it out.

What if allow filling caps only if "Extrude" = 0.