In D8904#225515, @Sybren A. Stüvel (sybren) wrote:

I don't really see the use of creating a new RNG for every "random" value, then initialising it with the same seed every time. This will just produce the same "random" value each time. How is this feature intended to work?

• Fix constness and format
• Clarify Randomize in UI and patch description
• Change Randomize to percentage

• Fix code style

Select Snap to: Vertex, Snap with: Center, press G and place your mouse cursor over a vertex, does it work?

• Fix randomize only applying to frame

I dont think this is a bug, the tooltip explains the On Surface applies the offset towards original location, in the first file, the middle vertices are inside the mesh, so the offset will be inside, on second file, final location and original location of most vertices are the same, so which direction will it go? apparently it wont move in this case, but probably by choise

not a bug, caused because you had 0 scale on z, and was solidifying to the z (local) direction

Happens here too

Mind that T70719 happens with meshes with no holes, not sure if its really a duplicate

Have you tried to decrease the Clip End or increasing Clip Start value? too high values may cause precision errors, your file is 10km end, try setting something as 100m, see if that helps