Page MenuHome

Fix T60226: Inset not working well on very small faces

Authored by Jacques Lucke (JacquesLucke) on Jan 28 2019, 5:28 PM.



The inset operator uses 0.01 as default for the inset.
When the face is very small than this default is very confusing (see T60226).

The simplest fix seems to be to just use 0 as default.
This is similar to the extrude operator which uses 0 as default as well.

Diff Detail

rB Blender

Event Timeline

This revision is now accepted and ready to land.Jan 28 2019, 7:08 PM

Note, we could enable "offset_relative" by default as an alternative.

Mostly this is accessed interactively though, so it's not that important AFAICS.

This revision was automatically updated to reflect the committed changes.